Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › KNOCK SENSOR
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106858 KNOCK SENSOR A

1AR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.
A196019C02
2.052,2.333 2.365,2.49 0.313,0.156 10 false *a 2.625,2.792 2.938,2.948 0.313,0.156 10 false *b 1.042,2.688 1.354,2.844 0.313,0.156 10 false *c 1.042,2.854 1.354,3.01 0.313,0.156 10 false *d
*a Top
*b Front of Engine
*c 7°
*d 10°


Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock control sensor has been struck or dropped, replace it.

·

Make sure that the knock control sensor is in the correct position.




b.

Connect the knock control sensor connector.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION