Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106859 AIR FUEL RATIO SENSOR A

1AR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.
A315109C01
1.354,2.365 2.156,2.74 2.156,2.74 2.198,1.906 false 0.948,2.688 1.26,2.844 0.313,0.156 10 false *a 1.438,0.906 1.615,1.083 0.177,0.177 10 true *b 2.042,2.781 2.375,2.979 0.333,0.198 10 false SST
*a Length of SST 30 mm (1.18 in.)
*b Length of Torque Wrench 260 mm (10.2 in.)


Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00010  

Torque:
without SST [Torque (N*m (kgf*cm, ft.*lbf))] : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))] : 39 N*m (398 kgf*cm, 29 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




b.

Connect the air fuel ratio sensor connector.


c.

Install the air fuel ratio sensor wire to the No. 1 radiator hose and engage the hose clamp.


Hide 17167 2.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION