Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106860 HEATED OXYGEN SENSOR A

1AR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

HINT:

Perform "Inspection After Repair" after replacing the heated oxygen sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.
A313529C01
2.469,0.708 3.021,0.563 3.021,0.563 2.781,2.167 true 2.427,2.885 2.74,3.042 0.313,0.156 10 false *a 1.76,1.49 1.979,1.708 0.219,0.219 10 true *b 2.938,0.313 3.281,0.51 0.344,0.198 10 true SST
*a Length of SST 30 mm (1.18 in.)
*b Length of Torque Wrench 260 mm (10.2 in.)


Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

SST
09224-00010  

Torque:
without SST [Torque (N*m (kgf*cm, ft.*lbf))] : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))] : 39 N*m (398 kgf*cm, 29 ft.*lbf)

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.


HINT:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




b.

Engage the 3 wire harness clamps.


c.

Connect the heated oxygen sensor connector.


Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the heated oxygen sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION