Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019662 2GR-FE ENGINE CONTROL _0106869 CRANKSHAFT POSITION SENSOR A

2GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A246907C08
1.677,0.958 2.052,0.5 false 2.094,0.396 2.323,0.594 0.229,0.198 10 false *a
*a O-ring


Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.




c.

Connect the crankshaft position sensor connector.


Hide 88310 2.INSTALL COMPRESSOR ASSEMBLY WITH PULLEY