Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
The license plate light bulb can be replaced by removing only the license plate light lens. It is not necessary to remove the license plate light assembly.
64783A
1.REMOVE BACK WINDOW UPPER TRIM PANEL
64792
2.REMOVE BACK DOOR TRIM COVER LH
64791C
3.REMOVE BACK DOOR TRIM COVER RH
Use the same procedure as for the LH side.
64798
4.REMOVE BACK DOOR LOCK COVER (for Glass Hatch Type)
67766
5.REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER
67765A
6.REMOVE NO. 1 BACK DOOR SERVICE HOLE COVER
64780A
7.REMOVE BACK DOOR TRIM PANEL ASSEMBLY
81270D
8.REMOVE LICENSE PLATE LIGHT ASSEMBLY
Disconnect the connector.
Disengage the 2 claws to remove the license plate light assembly.
81270B
9.REMOVE LICENSE PLATE LIGHT BULB
| *a | Insert into the hole |
|
Protective Tape |
Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it as shown in the illustration and disengage the 2 claws to remove the license plate light lens.
Remove the license plate light bulb.