Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM3160E _59 Vehicle Exterior _019722 LIGHTING (EXT) _0106952 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 55900 1.INSPECT AIR CONDITIONING CONTROL ASSEMBLY (HAZARD WARNING SIGNAL SWITCH)

a.
E190200
1.583,1.167 1.073,0.49 false 2.021,1.198 2.656,0.813 false 2.031,1.448 2.531,1.792 false 1.667,1.438 1.385,1.833 false 0.177,0.146 0.375,0.323 0.198,0.177 10 false *a 2.583,1.729 3.042,2 0.458,0.271 10 false GND 0.76,0.396 1.292,0.594 0.531,0.198 10 false ILL+ 2.719,0.719 3.25,0.917 0.531,0.198 10 false ILL- 1.25,1.854 1.708,2.125 0.458,0.271 10 false HAZ
*a Component without harness connected
(Air Conditioning Control Assembly (Hazard Warning Signal Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (GND) - 7 (HAZ) Hazard warning signal switch off 10 kΩ or higher
Hazard warning signal switch on Below 1 Ω


If the result is not as specified, replace the air conditioning control assembly.


b.

Illumination Inspection

i.

Apply battery voltage to the air conditioning control assembly and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 1 (ILL-)
Illuminates


If the result is not as specified, replace the air conditioning control assembly.