Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP › 2013.12–2016.11
RM3160E _52 Drivetrain _019725 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0107332 OIL PUMP G

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  INSPECTION  


PROCEDURE

Hide 35035 1.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

a.
C138512

Turn the front oil pump drive gear with 2 screwdrivers and check that it rotates smoothly.

NOTICE:

Be careful not to damage the front oil pump oil seal lip.



Hide 35035 2.INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

a.
C138509

Push the front oil pump driven gear to one side of the front oil pump body sub-assembly.


b.

Using a feeler gauge, measure the clearance.

Standard Clearance:

0.08 to 0.15 mm (0.00315 to 0.00591 in.)


Maximum Clearance:

0.15 mm (0.00591 in.)


If the clearance is greater than the maximum, replace the front oil pump body sub-assembly.


c.
C138511

Using a straightedge and feeler gauge, measure the side clearance of both gears.

Standard Side Clearance:

0.035 to 0.05 mm (0.00138 to 0.00197 in.)


Maximum Side Clearance:

0.05 mm (0.00197 in.)

Front Oil Pump Drive Gear Thickness
Mark Thickness
1 11.547 to 11.555 mm (0.4546 to 0.4549 in.)
2 11.555 to 11.563 mm (0.4549 to 0.4552 in.)
3 11.564 to 11.571 mm (0.4553 to 0.4556 in.)
4 11.572 to 11.579 mm (0.4556 to 0.4559 in.)
5 11.580 to 11.587 mm (0.4559 to 0.4562 in.)

Front Oil Pump Driven Gear Thickness
Mark Thickness
1 11.547 to 11.555 mm (0.4546 to 0.4549 in.)
2 11.555 to 11.563 mm (0.4549 to 0.4552 in.)
3 11.564 to 11.571 mm (0.4553 to 0.4556 in.)
4 11.572 to 11.579 mm (0.4556 to 0.4559 in.)
5 11.580 to 11.587 mm (0.4559 to 0.4562 in.)



Hide 35035 3.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

a.
C138514

Using a caliper gauge, measure the inside diameter of the front oil pump body sub-assembly bushing.

Standard Inside Diameter:

43.135 to 43.160 mm (1.69823 to 1.69920 in.)


Maximum Inside Diameter:

43.135 mm (1.69823 in.)


If the inside diameter is greater than the maximum, replace the front oil pump body sub-assembly.


Hide 35370 4.INSPECT STATOR SHAFT ASSEMBLY

a.
C138513

Using a caliper gauge, measure the inside diameter of the stator shaft assembly.

Standard Inside Diameter:

22.500 to 22.526 mm (0.88583 to 0.88684 in.)


Maximum Inside Diameter:

22.526 mm (0.88684 in.)


If the inside diameter is greater than the maximum, replace the stator shaft assembly.