51441
1.REMOVE NO. 1 ENGINE UNDER COVER
53876A
2.SEPARATE FRONT FENDER LINER LH
53737B
3.REMOVE FRONT FENDER APRON SEAL LH
4.DRAIN AUTOMATIC TRANSAXLE FLUID
Remove the refill plug and gasket from the automatic transaxle assembly.
Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle oil pan sub-assembly.
| *1 | No. 1 Transmission Oil Filler Tube |
| *a | Hexagon Socket Wrench |
| *b | Overflow Plug Hole |
Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle oil pan sub-assembly.
Drain the automatic transaxle fluid from the automatic transaxle assembly.
| *1 | No. 1 Transmission Oil Filler Tube |
| *a | Hexagon Socket Wrench |
| *b | Overflow Plug Hole |
Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle oil pan sub-assembly.
Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transaxle oil pan sub-assembly.
Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.
Temporarily install the gasket and refill plug to the automatic transaxle assembly.
Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.
5.REMOVE FRONT DRIVE SHAFT ASSEMBLY
43457
6.REMOVE DRIVE SHAFT BEARING BRACKET
43420H
7.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the automatic transaxle assembly.
Be careful not to damage the transaxle case sub-assembly.
43410M
8.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the automatic transaxle assembly.
Be careful not to damage the transaxle housing.
43420H
9.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
Using SST and a hammer, install a new front drive shaft oil seal LH to the automatic transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Make sure that the front drive shaft oil seal LH is installed in the correct direction.
Do not damage the front drive shaft oil seal LH lip.
Coat the lip of the front drive shaft oil seal LH with MP grease.
43410M
10.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
Using SST and a hammer, install a new front drive shaft oil seal RH to the automatic transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Make sure that the front drive shaft oil seal RH is installed in the correct direction.
Do not damage the front drive shaft oil seal RH lip.
Coat the lip of the front drive shaft oil seal RH with MP grease.
43457
11.INSTALL DRIVE SHAFT BEARING BRACKET
12.INSTALL FRONT DRIVE SHAFT ASSEMBLY
13.ADD AUTOMATIC TRANSAXLE FLUID
53737B
14.INSTALL FRONT FENDER APRON SEAL LH
53876A
15.INSTALL FRONT FENDER LINER LH
51441
16.INSTALL NO. 1 ENGINE UNDER COVER