Home › Steering › STEERING COLUMN › HEATED STEERING WHEEL SYSTEM
RM3160E _55 Steering _019698 STEERING COLUMN _0107380 HEATED STEERING WHEEL SYSTEM D

STEERING COLUMN  HEATED STEERING WHEEL SYSTEM  SYSTEM DESCRIPTION  


HEATED STEERING WHEEL SYSTEM


a.

The heated steering wheel system heats the steering wheel assembly when the steering heater switch is operated.


b.

The heated steering wheel system uses a thermistor inside of the steering wheel assembly to detect the heater temperature and maintain the set temperature.


c.

The heated steering wheel timer function turns off the heater after a predetermined period of time.



HEATER CONTROLLER SYSTEM


a.

Operation description

C300205
0.75,0.677 1.979,0.875 1.229,0.198 10 false OFF mode 0.75,0.979 2.583,1.177 1.833,0.198 10 false - Heater off 0.75,1.271 2.125,1.469 1.375,0.198 10 false - LED off 2.417,0.927 4.49,1.208 2.073,0.281 10 false Press steering heater switch 2.406,1.563 4.479,1.844 2.073,0.281 10 false Press steering heater switch 2.406,1.875 4.396,2.073 1.99,0.198 10 false After 30 min. 2.385,2.188 5.75,2.385 3.365,0.198 10 false Thermistor malfunction 2.375,2.51 4.969,2.948 2.594,0.438 10 false Press steering heater switch continuously for 10 sec. or more 4.448,0.646 6.135,0.896 1.688,0.25 10 false Normal warming mode 4.552,0.917 5.99,1.188 1.438,0.271 10 false - Heater on or off 4.604,1.198 6.427,1.448 1.823,0.25 10 false (depending on temperature) 4.542,1.5 5.844,1.771 1.302,0.271 10 false - LED illuminated

i.

When the ignition switch is turned to ON, pressing the steering heater switch illuminates the LED and current is output from the steering wheel heater control assembly to the steering wheel heater unit of the heated steering wheel system. Pressing the steering heater switch again turns off the LED and stops the current from being output.


ii.

A thermostat is installed in the steering wheel heater unit as a safety mechanism.


iii.

The steering heater switch LED will go off when either of the following occurs: 1) an open or short in the steering wheel heater unit thermistor continues for 2 seconds or more; or 2) the steering heater switch is pressed continuously for 10 seconds or more.


iv.

The timer will turn off the heater 30 minutes after the steering heater switch was first turned on.



b.

Signal input / output description

C147023
0.359,0.49 1.322,0.666 0.963,0.176 10 Power Source 0.347,1.164 1.826,1.339 1.480,0.176 10 Operation Switch Input 0.29,2.67 1.946,2.846 1.656,0.176 10 Temperature Setting Input 0.398,1.922 1.448,2.098 1.050,0.176 10 Thermistor Input 1.917,0.498 2.770,0.673 0.853,0.176 10 Latch Circuit 4.684,0.72 5.465,0.896 0.781,0.176 10 LED Output 4.606,1.391 5.529,1.548 0.923,0.157 10 Heater Output 6.29,1.391 6.625,1.548 0.335,0.157 10 FET 6.202,2.306 6.696,2.463 0.494,0.157 10 Heater 3.233,3.13 4.203,3.306 0.970,0.176 10 Microcomputer

Signal Signal Name Function Signal Type
Input Thermistor input Input of voltage corresponding to heater temperature Analog input
Input Temperature setting input Input of voltage corresponding to temperature setting Analog input
Input Operating switch input Input of power circuit latch operation estimate signal LOW / HI input
Output LED output Output of LED LOW / HI input
Output Heater output Output of heater LOW / HI input
Output Latch output Power circuit maintenance LOW / HI input


c.

Safety function

Content Operation
When thermistor malfunction is detected Heater off
When overheating (175°C (347°F)) of controller is detected Heater off
When load short current (50 A or more) is detected Heater off
When undervoltage (4.5 V) is detected Heater off
OFF timer (30 min.) After preset time of timer passes, heater off
Reverse voltage protection Protection circuit operates