Home › Drivetrain › MF1A (TRANSFER / 4WD / AWD) › TRANSFER OIL
RM3160E _52 Drivetrain _019685 MF1A TRANSFER / 4WD / AWD _0107522 TRANSFER OIL G

MF1A TRANSFER / 4WD / AWD  TRANSFER OIL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT TRANSFER OIL

a.
C141905

Remove the No. 1 transfer case plug and gasket from the transfer assembly.


b.
C083746
2.656,0.885 2.969,1.083 0.313,0.198 10 false *a
*a 0 to 5 mm (0 to 0.197 in.)


Check that the oil level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the case plug hole.

NOTICE:
·

When inspecting the transfer oil, make sure that the vehicle is level.

·

An excessively large or small amount of oil may cause damage.

·

After adding transfer oil, drive the vehicle and recheck the oil level.




c.

Check for oil leakage if the oil level is low.


d.

Install a new gasket to the No. 1 transfer case plug and then tighten the plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


Hide 2.ADJUST TRANSFER OIL

a.

Remove the No. 1 transfer case plug and gasket from the transfer assembly.


b.
C083746
2.646,0.885 2.958,1.042 0.313,0.156 10 false *a
*a 0 to 5 mm (0 to 0.197 in.)


Add transfer oil until the oil level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the case plug hole.

NOTICE:
·

When adding transfer oil, make sure that the vehicle is level.

·

Add transfer oil a little at a time, waiting several minutes between each addition of transfer oil.

·

After adding transfer oil, drive the vehicle and recheck the oil level.



Oil Type:

Toyota Genuine Differential gear oil LT API GL-5 or equivalent


Viscosity:

SAE 75W-85


Standard Capacity:

0.8 liters (0.8 US qts, 0.7 Imp.qts)



c.

After waiting for approximately 5 minutes, recheck the oil level.


d.

Install a new gasket and the No. 1 transfer case plug to the transfer assembly.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)