Home › Drivetrain › MF1A (TRANSFER / 4WD / AWD) › 4WD CONTROL SWITCH
RM3160E _52 Drivetrain _019685 MF1A TRANSFER / 4WD / AWD _0107527 4WD CONTROL SWITCH G

MF1A TRANSFER / 4WD / AWD  4WD CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84725A 1.INSPECT DIFFERENTIAL LOCK SWITCH

a.
C281336
1.979,1.604 2.198,1.958 2.198,1.958 2.344,1.958 true 1.531,1.594 1.417,1.948 1.417,1.948 1.26,1.948 true 0.052,0.052 0.365,0.208 0.313,0.156 10 false *a 2.417,1.865 2.573,2.063 0.156,0.198 10 false L 0.948,1.885 1.417,2.073 0.469,0.188 10 false CPU
*a Component without harness connected (Differential Lock Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (L) - 9 (CPU) Differential lock switch on (Push) Below 1 Ω
Differential lock switch off (Release) 10 kΩ or higher


If the result is not as specified, replace the differential lock switch.


b.
C281336
1.833,1.604 2.042,1.948 2.042,1.948 2.24,1.948 false 1.677,1.594 1.531,1.938 1.531,1.938 1.323,1.938 false 0.052,0.052 0.365,0.208 0.313,0.156 10 false *a 2.333,1.854 2.646,2.01 0.313,0.156 10 false ILL- 1.01,1.865 1.323,2.021 0.313,0.156 10 false ILL+
*a Component without harness connected (Differential Lock Switch)


Apply battery voltage between the terminals of the switch, and check the illumination condition of the differential lock switch.

Standard:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 7 (ILL-)
Illuminates


If the result is not as specified, replace the differential lock switch.