Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY(for 1AR-FE)
RM3160E _52 Drivetrain _019686 DRIVE SHAFT / PROPELLER SHAFT _0107993 FRONT DRIVE SHAFT ASSEMBLY(for 1AR-FE) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 1AR-FE)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C091598

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C240884C02
0.115,1.656 0.969,1.917 0.854,0.26 10 false *B 0.115,0.052 0.74,0.375 0.625,0.323 10 false *A 1.458,1.406 1.729,1.656 0.271,0.25 10 false A 1.521,2.958 1.792,3.219 0.271,0.26 10 false A
*A for LH Side
*B for RH Side


Check whether each drive shaft dimension (A) is within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


Dimension (A):
for LH Side 602.36 mm (1.98 ft.)
for RH Side 918.96 mm (3.01 ft.)