Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY(for 2GR-FE) › 2013.12–2016.11
RM3160E _52 Drivetrain _019686 DRIVE SHAFT / PROPELLER SHAFT _0107994 FRONT DRIVE SHAFT ASSEMBLY(for 2GR-FE) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 2GR-FE)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C091598

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C240884C02
0.115,1.656 0.969,1.917 0.854,0.26 10 false *B 0.115,0.052 0.74,0.375 0.625,0.323 10 false *A 1.458,1.406 1.729,1.656 0.271,0.25 10 false A 1.521,2.958 1.792,3.219 0.271,0.26 10 false A
*A for LH Side
*B for RH Side


Check whether each drive shaft dimension (A) is within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


Dimension (A) (for 2WD):
for LH Side 604.44 mm (1.98 ft.)
for RH Side 921.64 mm (3.02 ft.)


Dimension (A) (for AWD):
for LH Side 604.44 mm (1.98 ft.)
for RH Side 924.14 mm (3.03 ft.)