Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM3160E _52 Drivetrain _019686 DRIVE SHAFT / PROPELLER SHAFT _0107997 PROPELLER SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT SPIDER BEARING

a.
C166052

Check that the spider bearing rotates smoothly.


b.
C296183

Check that there is no play in the spider bearing.

If necessary, replace the propeller with center bearing shaft assembly.


Hide 2.INSPECT INTERMEDIATE SHAFT ASSEMBLY

a.
C166053

Using a dial indicator, measure the runout of the intermediate shaft assembly.

Maximum Runout:

0.4 mm (0.0157 in.)


NOTICE:

The dial indicator must be set at a right angle to the center of the intermediate shaft assembly.


If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.


b.
C166054

Using a dial indicator, measure the runout of the universal joint flange (for front side).

Maximum Runout:

0.1 mm (0.00394 in.)


If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.


c.
C166056

Using a dial indicator, measure the runout of the universal joint flange (for rear side).

Maximum Runout:

0.1 mm (0.00394 in.)


If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.


Hide 3.INSPECT PROPELLER SHAFT ASSEMBLY

a.
C166057

Using a dial indicator, measure the runout of the propeller shaft assembly.

Maximum Runout:

0.4 mm (0.0157 in.)


NOTICE:

The dial indicator must be set at a right angle to the center of the propeller shaft assembly.


If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.


Hide 4.INSPECT REAR PROPELLER SHAFT ASSEMBLY

a.
C167205

Using a dial indicator, measure the runout of the rear propeller shaft assembly.

Maximum Runout:

0.4 mm (0.0157 in.)


NOTICE:

The dial indicator must be set at a right angle to the center of the rear propeller shaft assembly.


If the shaft runout exceeds the maximum, replace the propeller with center bearing shaft assembly.


Hide 37230J 5.INSPECT NO. 2 CENTER SUPPORT BEARING ASSEMBLY

a.
C166058

Turn the No. 2 center support bearing assembly by hand in the rotating direction.


b.

Check that the No. 2 center support bearing assembly turns smoothly, and check that the seals are not cracked or damaged.

If the No. 2 center support bearing assembly is damaged or worn, or does not turn smoothly, replace it.