Home › Brake › PARKING BRAKE › PARKING BRAKE ASSEMBLY
RM3160E _54 Brake _019696 PARKING BRAKE _0108002 PARKING BRAKE ASSEMBLY G

PARKING BRAKE  PARKING BRAKE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE DISC INSIDE DIAMETER

a.
C132647

Using a brake drum gauge or an equivalent tool, measure the inside diameter of the disc.

Standard Inside Diameter:

210 mm (8.27 in.)


Maximum Inside Diameter:

211 mm (8.31 in.)


If the inside diameter is more than the maximum, replace the rear disc.


Hide 2.INSPECT PARKING BRAKE SHOE LINING THICKNESS

a.
C166158

Using a ruler, measure the thickness of the parking brake shoe lining.

Standard Thickness:

3.85 mm (0.152 in.)


Minimum Thickness:

1.0 mm (0.0394 in.)


If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe assembly.

NOTICE:

Always replace both right and left parking brake shoes together.



Hide 3.INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT

a.
C166159

Apply chalk to the inside surface of the disc, then slide the brake shoe against the disc to check the fit of the brake shoe lining to the disc.

If the contact between the disc and the brake shoe lining is incorrect, repair the lining using a brake shoe grinder or replace the parking brake shoe assembly.

NOTICE:
·

Always replace both right and left parking brake shoes together.

·

Wipe off the chalk after inspection.