85292B
1.REMOVE FRONT WIPER ARM HEAD CAP
| *a | Protective Tape |
Using a screwdriver, disengage the 3 claws to remove the front wiper arm head cap.
Tape the screwdriver tip before use.
Use the same procedure for the RH side and LH side.
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the nut and front wiper arm and blade assembly LH.
3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
Remove the nut and front wiper arm and blade assembly RH.
53867H
4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
Disengage the 2 claws and remove the front fender to cowl side seal LH.
53866J
5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Use the same procedure as for the LH side.
55781E
6.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Remove the 2 clips.
Disengage the 6 claws and 3 guides as shown in the illustration.
Disengage the 8 guides and remove the cowl top ventilator louver sub-assembly as shown in the illustration.
7.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Disconnect the connector.
| *a | Motor Grommet |
Remove the 2 bolts.
Disengage the motor grommet as shown in the illustration and remove the windshield wiper motor and link assembly.
Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.
85012A
8.REMOVE FRONT WIPER CRANK SUB-ASSEMBLY
| *a | Protective Tape |
| *b | Pivot of the front wiper crank sub-assembly |
Using a screwdriver, separate the windshield wiper link No. 1 rod from the pivot of the front wiper crank sub-assembly as shown in the illustration.
Tape the screwdriver tip before use.
Remove the nut and front wiper crank sub-assembly.
85110
9.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the windshield wiper link assembly.