Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0108077 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the front speed sensor rotor needs to be replaced, replace the front drive shaft assembly.



PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR

a.

Install the front speed sensor to the steering knuckle with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Prevent foreign matter from attaching to the front speed sensor tip.

·

Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

·

After installing the front speed sensor to the steering knuckle, make sure that there is no clearance between the front speed sensor stay and steering knuckle. Also make sure that no foreign matter is stuck between the parts.

·

Do not twist the front speed sensor wire harness when installing it.




b.

Engage the 2 claws to install the sensor clamp.

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



c.
C292840

Engage the 2 claws to install the sensor clamp bracket.

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



d.
C292839

Install the front flexible hose with the bolt.

Torque:
18.8 N*m (192 kgf*cm, 14 ft.*lbf)


e.

Install the sensor clamp with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



f.

Engage the 2 sensor clamps.

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



g.

Connect the front speed sensor connector.


Hide 53876A 2.INSTALL FRONT FENDER LINER

a.

Install the front fender liner with the screw and clip.


Hide 3.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION