Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0108077 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the front speed sensor rotor needs to be replaced, replace the front drive shaft assembly.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE FRONT WHEEL

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53876A 4.SEPARATE FRONT FENDER LINER

C292835

a.

Remove the screw and clip and separate the front fender liner.


Hide 89543 5.REMOVE FRONT SPEED SENSOR

a.
C292836

Disconnect the front speed sensor connector.


b.

Disengage the 2 sensor clamps.


c.
C292837

Remove the bolt and sensor clamp bracket.


d.
C292838

Remove the bolt and separate the front flexible hose and sensor clamp bracket.


e.
C292841

Disengage the 2 claws to separate the sensor clamp.


f.

Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
·

Prevent foreign matter from attaching to the front speed sensor tip.

·

Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.