Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR(for AWD)
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0108079 REAR SPEED SENSOR(for AWD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for AWD)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

The rear speed sensor rotor is a component of the rear axle hub and bearing assembly. If the rear speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR WHEEL

Hide 89546 4.REMOVE REAR SPEED SENSOR LH

a.

w/ Height Control Sensor:

i.
C292844

Disengage the wire harness clamp from the rear speed sensor LH.



b.
C292845

Disconnect the rear speed sensor connector.


c.

Remove the nut and separate the sensor clamp from the rear suspension member sub-assembly.


d.
C292846

Remove the 2 bolts and separate the 2 sensor clamps from the rear upper control arm assembly LH.


e.
C292847

Remove the 2 bolts, sensor clamp and rear speed sensor LH from the rear axle carrier sub-assembly LH and rear trailing arm assembly LH.

NOTICE:
·

Prevent foreign matter from attaching to the rear speed sensor tip.

·

Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.




Hide 89545 5.REMOVE REAR SPEED SENSOR RH

a.
C292848

Disconnect the rear speed sensor connector.


b.

Remove the nut and separate the sensor clamp from the rear suspension member sub-assembly.


c.
C292849

Remove the 2 bolts and separate the 2 sensor clamps from the rear upper control arm assembly RH.


d.
C292850

Remove the 2 bolts, sensor clamp and rear speed sensor RH from the rear axle carrier sub-assembly RH and rear trailing arm assembly RH.

NOTICE:
·

Prevent foreign matter from attaching to the rear speed sensor tip.

·

Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.