Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0108081 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84988L 1.INSPECT VSC OFF SWITCH

a.
C239020C04
1.885,2.042 2.479,2.875 true 1.521,2.052 0.948,2.875 true 0.323,0.313 0.969,0.656 0.646,0.344 10 *a 2.427,2.885 2.885,3.146 0.458,0.26 10 E 0.854,2.885 1.333,3.25 0.479,0.365 10 +
*a Component without harness connected
(VSC OFF Switch)


Make sure that there is no looseness at the locking part and the connecting part of the connector.


b.

Disconnect the VSC OFF switch connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (+) - 3 (E) Switch pushed Below 1 Ω
6 (+) - 3 (E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the VSC OFF switch.