Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0108082 DOWNHILL ASSIST CONTROL SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DOWNHILL ASSIST CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84988H 1.INSPECT DOWNHILL ASSIST CONTROL SWITCH

a.
C296498C01
1.542,1.594 1.833,0.833 false 1.833,2.75 1.531,1.938 false 0.229,0.271 0.542,0.469 0.313,0.198 10 false *a 1.833,0.656 2.146,0.854 0.313,0.198 10 false B 1.823,2.792 2.135,2.99 0.313,0.198 10 false E
*a Component without harness connected
(Downhill Assist Control Switch)


Make sure that there is no looseness in the locking part and the connecting part of the connector.


b.

Disconnect the downhill assist control switch connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (B) - 1 (E) Switch pushed Below 1 Ω
4 (B) - 1 (E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the downhill assist control switch.