86011V
1.INSTALL RADIO SETTING CONDENSER
Engage the claw to install a new terminal cover to the wire harness.
Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.
Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.
Do not use excessive force when inserting the terminal covers into the condenser.
If a terminal cover has been deformed during installation, replace the terminal, terminal covers and condenser with new ones.
Insert the cover as shown in the illustration and engage the claw.
Engage the clamp to temporarily install the new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
62480A
2.INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH
64740C
3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
66311
4.INSTALL ROPE HOOK
64725F
5.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64974
6.INSTALL DECK TRIM POCKET COVER
73570
7.CONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH
64715E
8.INSTALL NO. 2 DECK SIDE TRIM COVER
73370C
9.CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
64713F
10.INSTALL FRONT DECK SIDE TRIM COVER LH
11.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918A
12.INSTALL REAR DOOR SCUFF PLATE LH
72138M
13.INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH
14.INSTALL REAR NO. 2 SEAT ASSEMBLY
58387B
15.INSTALL REAR FLOOR FINISH PLATE
64993
16.INSTALL REAR DECK FLOOR BOX
64742C
17.INSTALL DECK SIDE TRIM BOX LH
64910J
18.INSTALL TONNEAU COVER ASSEMBLY
58409A
19.INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
58410B
20.INSTALL DECK BOARD ASSEMBLY