Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3160E _56 Audio / Visual / Telematics _019700 AUDIO / VIDEO _0108141 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 58410B 1.REMOVE DECK BOARD ASSEMBLY

Hide 58409A 2.REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

Hide 64910J 3.REMOVE TONNEAU COVER ASSEMBLY

Hide 64742C 4.REMOVE DECK SIDE TRIM BOX LH

Hide 64993 5.REMOVE REAR DECK FLOOR BOX

Hide 58387B 6.REMOVE REAR FLOOR FINISH PLATE

Hide 7.REMOVE REAR NO. 2 SEAT ASSEMBLY

Hide 72138M 8.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH

Hide 67918A 9.REMOVE REAR DOOR SCUFF PLATE LH

Hide 10.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 64713F 11.REMOVE FRONT DECK SIDE TRIM COVER LH

Hide 73370C 12.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

Hide 64715E 13.REMOVE NO. 2 DECK SIDE TRIM COVER

Hide 73570 14.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH

Hide 64974 15.REMOVE DECK TRIM POCKET COVER

Hide 64725F 16.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64740C 18.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 62480A 19.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

Hide 86011V 20.REMOVE RADIO SETTING CONDENSER

NOTICE:

When a terminal cover is removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.


a.
E287608

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E226094

Disengage the claw and pull out the cover as shown in the illustration.


d.
E232601

Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.


e.
E223708

Using a screwdriver, bend back and break off the claw as shown in the illustration.


f.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.