1.REMOVE REAR BUMPER ASSEMBLY
89341A
2.REMOVE NO. 1 ULTRASONIC SENSOR
Use the same procedure for all No. 1 ultrasonic sensors.
Disengage the 2 claws.
This illustration is for the LH side. The orientation for the other side is the opposite of the LH side.
Disconnect the connector to remove the No. 1 ultrasonic sensor.
89359
3.REMOVE ULTRASONIC SENSOR BEZEL
Use the same procedure for all ultrasonic sensor bezels.
Disengage the 4 claws and remove the ultrasonic sensor bezel from the rear bumper assembly.
This illustration is for the LH side. The orientation for the other side is the opposite of the LH side.