Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH
RM3160E _56 Audio / Visual / Telematics _019702 PARK ASSIST / MONITORING _0108150 CLEARANCE SONAR MAIN SWITCH G

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490A 1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

a.
E197324
1.563,1.385 1.563,1.656 1.563,1.656 1.052,1.656 false 2.01,1.375 2.01,1.656 2.01,1.656 2.521,1.656 false 0.833,1.583 1.146,1.802 0.313,0.219 10 false IG 2.604,1.563 3.073,1.781 0.469,0.219 10 false ECU 0.115,0.063 0.49,0.344 0.375,0.281 10 false *a
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
9 (IG) - 6 (ECU) Back sonar or clearance sonar switch assembly pushed Below 1 Ω
9 (IG) - 6 (ECU) Back sonar or clearance sonar switch assembly not pushed 10 kΩ or higher


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.


b.

Check that the switch illuminates.

i.
E197324
1.729,1.365 1.729,1.604 1.729,1.604 1.219,1.604 false 1.865,1.365 1.865,1.604 1.865,1.604 2.375,1.604 false 0.927,1.531 1.323,1.708 0.396,0.177 10 false ILL+ 2.417,1.531 2.76,1.698 0.344,0.167 10 false ILL- 0.115,0.063 0.323,0.229 0.208,0.167 10 false *a
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


Apply battery voltage to the back sonar or clearance sonar switch assembly and check that the switch illuminates.

OK:
Tester Connection Specified Condition
Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 7 (ILL-)
Illuminates


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.