Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH › 2013.12–2016.11
RM3160E _56 Audio / Visual / Telematics _019702 PARK ASSIST / MONITORING _0108152 BLIND SPOT MONITOR MAIN SWITCH G

PARK ASSIST / MONITORING  BLIND SPOT MONITOR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84470 1.INSPECT BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY)

a.
E224422
1.49,1.469 1.281,1.802 false 2,1.469 2.208,1.802 false 0.323,0.198 0.635,0.49 0.313,0.292 10 false *a 2.188,1.823 2.354,1.969 0.167,0.146 10 false D 1.219,1.823 1.385,1.969 0.167,0.146 10 false B
*a Component without harness connected
(Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
11 (B) - 8 (D) Blind spot monitor main switch on (not protruding) Below 1 Ω
11 (B) - 8 (D) Blind spot monitor main switch off (protruding) 10 kΩ or higher


If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).


b.

Check that the blind spot monitor indicator illuminates.

i.
E224422
1.479,1.448 1.75,1.844 false 1.323,1.458 1.083,1.833 false 0.323,0.198 0.635,0.49 0.313,0.292 10 false *a 1.75,1.854 1.917,2 0.167,0.146 10 false B 1,1.854 1.167,2 0.167,0.146 10 false E
*a Component without harness connected
(Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))


Apply battery voltage to the blind spot monitor main switch (warning canceling switch assembly) connector and check operation of the blind spot monitor indicator, as shown in the table below.

OK:
Connection Condition Specified Condition
Battery positive (+) → Terminal 11 (B)
Battery negative (-) → Terminal 12 (E)
Blind spot monitor main switch on (not protruding) Blind spot monitor indicator illuminates
Blind spot monitor main switch off (protruding) Blind spot monitor indicator does not illuminate


If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).



c.

Check that the switch illuminates.

i.
E224422
1.635,1.448 1.396,1.802 false 1.833,1.458 2.042,1.792 false 0.323,0.198 0.635,0.49 0.313,0.292 10 *a 1.25,1.813 1.771,2.104 0.521,0.292 10 ILL+ 2,1.833 2.396,2.021 0.396,0.188 10 ILL-
*a Component without harness connected
(Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))


Apply battery voltage to the blind spot monitor main switch (warning canceling switch assembly) and check that the switch illuminates.

OK:
Connection Specified Condition
Battery positive (+) → Terminal 10 (ILL+)
Battery negative (-) → Terminal 9 (ILL-)
Illuminates


If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).