Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM3160E _58 Vehicle Interior _019705 DOOR LOCK _0098509 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH side.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 69760C 2.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

Hide 69720B 3.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

Hide 69040A 4.INSTALL FRONT DOOR LOCK WITH MOTOR ASSEMBLY

NOTICE:
·

When reusing a removed front door lock with motor assembly, replace the door lock wiring harness seal with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

·

Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door lock with motor assembly.



a.

Apply MP grease to the sliding parts of the front door lock with motor assembly.


b.

When reusing the front door lock with motor assembly:

i.
B360815

Install a new door lock wiring harness seal to the front door lock with motor assembly.



c.
B360807C03
3.094,2.771 3.01,2.604 true 3.031,2.802 3.281,3.01 0.25,0.208 10 true *1
*1 Front Door Lock Open Rod


Connect the front door lock open rod to the front door lock with motor assembly.

HINT:

Make sure that the front door lock open rod is securely connected to the front door lock with motor assembly.



d.

Using a T30 "TORX" socket wrench, install the front door lock with motor assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


e.

Connect the connector.


Hide 5.INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

Hide 67404F 6.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 68151D 7.INSTALL FRONT DOOR GLASS RUN

Hide 68102 8.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 9.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67602 10.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 81230N 11.INSTALL COURTESY LIGHT ASSEMBLY

Hide 12.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 13.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 69284C 14.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 67492A 15.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17.INITIALIZE POWER WINDOW CONTROL SYSTEM

Hide 18.INSPECT POWER WINDOW OPERATION