Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH
RM3160E _59 Vehicle Exterior _019719 DOOR / HATCH _0108190 BACK DOOR OPENER SWITCH G

DOOR / HATCH  BACK DOOR OPENER SWITCH  INSPECTION  


PROCEDURE

Hide 84840G 1.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/ Smart Entry and Start System)

a.

Check the operation of the opener switch.

i.
B142645
1.719,1.396 2.198,1.844 false 1.01,1.844 1.49,1.406 false 2.104,1.875 2.563,2.083 0.458,0.208 10 false GND 0.177,0.167 0.333,0.323 0.156,0.156 10 false *a 0.781,1.865 1.406,2.146 0.625,0.281 10 false BDSU
*a Component without harness connected
(Back Door Opener Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (GND) - 3 (BDSU) Back door opener switch not pushed 10 kΩ or higher
2 (GND) - 3 (BDSU) Back door opener switch pushed Below 1 Ω


If the result is not as specified, replace the back door opener switch assembly.



b.

Check the operation of the lock switch.

i.
B142645
1.948,1.396 2.427,1.844 false 1.229,1.844 1.708,1.406 false 2.302,1.865 2.813,2.104 0.51,0.24 10 false TSW5 0.177,0.167 0.333,0.323 0.156,0.156 10 false *a 1.115,1.865 1.573,2.115 0.458,0.25 10 false GND
*a Component without harness connected
(Back Door Opener Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (TSW5) - 2 (GND) Back door lock switch not pushed 10 kΩ or higher
1 (TSW5) - 2 (GND) Back door lock switch pushed Below 1 Ω


If the result is not as specified, replace the back door opener switch assembly.



Hide 84840G 2.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/o Smart Entry and Start System)

a.

Check the operation of the opener switch.

i.
B142645
1.719,1.396 2.198,1.844 false 1.01,1.844 1.49,1.406 false 2.104,1.875 2.563,2.083 0.458,0.208 10 false GND 0.177,0.167 0.333,0.323 0.156,0.156 10 false *a 0.781,1.865 1.406,2.146 0.625,0.281 10 false BDSU
*a Component without harness connected
(Back Door Opener Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (GND) - 3 (BDSU) Back door opener switch not pushed 10 kΩ or higher
2 (GND) - 3 (BDSU) Back door opener switch pushed Below 1 Ω


If the result is not as specified, replace the back door opener switch assembly.