84931F
1.INSPECT REAR DOOR CONTROL SWITCH
Check the operation of the rear door control switch.
| *a | Component without harness connected
(Rear Door Control Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (MSE) - 4 (MSW) | Rear door control switch not pushed | 10 kΩ or higher |
| 1 (MSE) - 4 (MSW) | Rear door control switch pushed | Below 1 Ω |
If the result is not as specified, replace the back rear door control switch.
| *a | Component without harness connected
(Rear Door Control Switch) |
Check that the switch illuminates.
Apply battery voltage to the power back rear door control switch and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3 (ILL+)
Battery negative (-) → 2 (ILL-) |
LED illuminates |
If the result is not as specified, replace the back rear door control switch.