84931C
1.INSPECT BACK DOOR CONTROL SWITCH
Check the operation of the back door control switch.
| *a | Component without harness connected
(Back Door Control Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (CLS) - 1 (E) | Back door control switch not pushed | 10 kΩ or higher |
| Back door control switch pushed | Below 1 Ω |
If the result is not as specified, replace the back door control switch.
| *a | Component without harness connected
(Back Door Control Switch) |
Check that the switch illuminates.
Apply battery voltage to the power back door control switch and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3 (ILL+)
Battery negative (-) → 2 (ILL-) |
LED illuminates |
If the result is not as specified, replace the back door control switch.