When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) must be registered, so be sure to make a note of the automatic open stop position.
64783A
1.REMOVE BACK WINDOW UPPER TRIM PANEL
64792
2.REMOVE BACK DOOR TRIM COVER LH
64791C
3.REMOVE BACK DOOR TRIM COVER RH
Use the same procedure as for the LH side.
64798
4.REMOVE BACK DOOR LOCK COVER (for Glass Hatch Type)
67766
5.REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER
67765A
6.REMOVE NO. 1 BACK DOOR SERVICE HOLE COVER
64780A
7.REMOVE BACK DOOR TRIM PANEL ASSEMBLY
89222A
8.REMOVE MULTIPLEX NETWORK DOOR ECU
Disconnect the 2 connectors.
Remove the 2 screws.
Disengage the clip and guide to remove the multiplex network door ECU.