Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM3160E _59 Vehicle Exterior _019719 DOOR / HATCH _0108198 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 68948 1.INSTALL BACK DOOR DAMPER STAY LOWER BRACKET

a.

Clean the bolt holes portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door damper stay lower bracket with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 68946 2.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET

a.

Clean the bolt holes on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door damper stay upper bracket with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 68960 3.INSTALL BACK DOOR STAY ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.



a.

When reusing the back door stay assembly:

i.
B363203

Install the 2 stop rings to the back door stay assembly.



b.
B363204

Install the back door stay assembly.

NOTICE:

Install the back door stay assembly while supporting the back door by hand.



c.

Check that the back door stay assembly is engaged to the ball joints and that the back door stay assembly cannot be pulled out.