84841A
1.INSPECT FUEL LID OPENER SWITCH
| *a | Component without harness connected
(Fuel Lid Opener Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (B) - 1 (L) | Pushed (ON) | Below 1 Ω |
| 4 (B) - 1 (L) | Not pushed (OFF) | 10 kΩ or higher |
If the result is not as specified, replace the fuel lid opener switch.
Check that the switch illuminates.
Apply battery voltage to the fuel lid opener switch and check that the switch illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3 (ILL+)
Battery negative (-) → 2 (ILL-) |
Illuminates |
If the result is not as specified, replace the fuel lid opener switch.