Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM3160E _58 Vehicle Interior _019713 SEAT BELT _0108221 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67914 3.REMOVE FRONT DOOR SCUFF PLATE

Hide 4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the front door opening trim weatherstrip.


Hide 72138M 5.REMOVE REAR OUTER SEAT TRACK BRACKET COVER

Hide 67918A 6.REMOVE REAR DOOR SCUFF PLATE

Hide 7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the rear door opening trim weatherstrip.


Hide 62414A 8.REMOVE LOWER CENTER PILLAR GARNISH

Hide 73220 9.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B361262

Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.


Hide 62412 10.REMOVE CENTER PILLAR GARNISH

Hide 73220 11.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B361260

Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.


b.
B361254C01
0.938,0.948 1.417,1.24 true 0.313,0.844 0.49,1.01 true 0.156,0.75 0.354,0.917 0.198,0.167 10 false *a 1.469,1.219 1.688,1.427 0.219,0.208 10 false *b 0.698,0.292 0.927,0.479 0.229,0.188 10 false *c
*a Protective Tape
*b Locking Button
*c Release


Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



c.
B361258

Remove the 2 bolts and front seat outer belt assembly.


Hide 73200A 12.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

a.
B361259

Remove the 2 bolts.


b.

Disengage the guide to remove the front shoulder belt anchor adjuster assembly.