Home › Engine / Hybrid System › 2GR-FE FUEL › FUEL INJECTOR › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019664 2GR-FE FUEL _0108302 FUEL INJECTOR G

2GR-FE FUEL  FUEL INJECTOR  INSPECTION  


PROCEDURE

Hide 23250 1.INSPECT FUEL INJECTOR ASSEMBLY

a.
A182852C02
0.656,0.115 1.875,0.969 1.219,0.854 0.76,0.146 1.073,0.302 0.313,0.156 10 false *a
*a Component without harness connected
(Fuel Injector Assembly)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 11.6 to 12.4 Ω


If the result is not as specified, replace the fuel injector assembly.



b.

Check the operation.

CAUTION:

Perform the inspection in a well-ventilated area.

Do not perform the inspection near an open flame.


i.
A264971C19
0.5,1.656 0.729,1.885 0.729,1.885 0.833,1.885 false 0.854,0.906 1.146,0.615 1.146,0.615 1.26,0.615 false 1.99,1.292 2.292,1.594 2.292,1.594 2.417,1.594 false 2.646,0.698 2.948,0.396 2.948,0.396 3.063,0.396 false 0.875,1.802 1.156,2.042 0.281,0.24 10 false *a 1.333,0.521 1.656,0.781 0.323,0.26 10 false *b 2.479,1.51 2.802,1.76 0.323,0.25 10 false *c 3.135,0.292 3.354,0.542 0.219,0.25 10 false *d
*a SST (Hose)
*b SST (Hose Band)
*c SST (Fuel Tube Connector)
*d Fuel Pipe (Vehicle Side)


Connect SST (fuel tube connector) to SST (hose) with SST (hose band), and then connect them to the fuel pipe (vehicle side).

SST
09268-31014  (09268-41500, 09268-41700, 95336-08070)


ii.

Apply a light coat of gasoline to a new O-ring. Then install the O-ring onto the fuel injector assembly.


iii.
A264982C04
1.333,0.135 0.958,0.135 false 1.729,0.333 2.021,0.333 false 1.302,0.771 0.958,0.771 false 1.5,1.167 1.667,1.167 false 2.104,1.448 2.448,1.448 false 1.323,1.875 0.979,1.875 false 0.771,0.031 0.958,0.198 0.188,0.167 10 false *a 2.083,0.25 2.25,0.427 0.167,0.177 10 false *b 0.781,0.677 0.948,0.854 0.167,0.177 10 false *c 1.708,1.083 1.875,1.26 0.167,0.177 10 false *1 2.5,1.365 2.667,1.542 0.167,0.177 10 false *d 0.792,1.792 0.958,1.969 0.167,0.177 10 false *e
*1 O-ring
*a SST (Hose)
*b SST (Hose Band)
*c SST (Adapter)
*d SST (Clamp)
*e Vinyl Tube


Connect SST (adapter) and SST (hose) to the fuel injector assembly, and hold the fuel injector assembly and union with SST (clamp).

SST
09268-31014  (09268-41141, 09268-41410, 09268-41700, 95336-08070)


iv.

Install a vinyl tube onto the fuel injector assembly.

CAUTION:

Install a suitable vinyl tube onto the fuel injector assembly to prevent fuel from spraying.



v.
A261671C04
2.01,1.708 2.219,1.917 2.219,1.917 2.302,1.917 false 1.906,0.396 2.313,0.396 false 1.229,0.615 0.844,0.615 false 2.385,0.313 2.563,0.5 0.177,0.188 10 false *b 0.646,0.531 0.906,0.76 0.26,0.229 10 false *a 2.365,1.833 2.542,2.021 0.177,0.188 10 false *c
*a SST (Tie Band)
*b SST (Adapter)
*c SST (Clamp)


Tie SST (clamp) and SST (adapter) together with SST (tie band) as shown in the illustration.

SST
09268-31014  (09268-41141, 09268-41410, 09268-41800)


vi.

Set the fuel injector assembly in a graduated cylinder.



viii.
A264973C20
2.01,0.542 2.01,0.958 false 1.948,1.01 2.219,1.292 0.271,0.281 10 *a 1.052,1.365 1.385,1.635 0.333,0.271 10 *b
*a SST (Wire)
*b Connect


Connect SST (wire) to the fuel injector assembly and battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each fuel injector assembly 2 or 3 times.

SST
09842-30080  

Standard Injection Volume:
Battery Connection Condition Specified Condition
Positive (+) battery terminal - Negative (-) battery terminal Per 15 seconds 84 to 101 cc (5.1 to 6.2 cu.in.)


Difference between Each Fuel Injector Assembly:

17 cc (1.0 cu.in.) or less


NOTICE:

Always switch the voltage on and off at the battery side, not the fuel injector assembly side.


If the result is not as specified, replace the fuel injector assembly.



c.

Check for leaks.

i.

Disconnect SST (wire) from the battery and check for fuel leaks from the fuel injector assembly.

Standard Fuel Drop:

1 drop or less every 35 minutes


If fuel drop is not as specified, replace the fuel injector assembly.