Home › Engine / Hybrid System › 2GR-FE FUEL › FUEL PUMP › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019664 2GR-FE FUEL _0108304 FUEL PUMP G

2GR-FE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.
A171472N06
0.948,1.24 0.802,1.313 0.802,1.313 0.5,1.313 false 1.25,1.25 1.417,1.313 1.417,1.313 1.74,1.313 false 0.344,1.25 0.469,1.51 0.125,0.26 10 false 1 1.823,1.24 1.969,1.49 0.146,0.25 10 false 2 1.333,1.333 1.49,1.531 0.156,0.198 10 false + 0.802,1.333 0.958,1.531 0.156,0.198 10 false -

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check the operation.

i.

Apply battery voltage to both terminals. Check that the fuel pump operates.

NOTICE:
·

Perform this test within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always switch the voltage on and off at the battery side, not the fuel pump side.



If the fuel pump does not operate, replace the fuel pump.