1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55410C
3.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Disengage the 4 clips and 2 guides as shown in the illustration.
Disengage the 9 claws and 2 guides and remove the instrument cluster finish panel assembly as shown in the illustration.
83100
4.REMOVE COMBINATION METER ASSEMBLY
Remove the 2 screws.
Disengage the 2 clips as shown in the illustration.
Disconnect the 2 connectors to remove the combination meter assembly.