Perform the removal and installation of the front disc brake piston, cylinder boot and piston seal one side at a time.
47731
1.REMOVE FRONT DISC BRAKE PISTON
| *a | Cloth |
| *b | Wooden Block |
Place a piece of cloth and a wooden block between the front disc brake piston and front disc brake cylinder.
Make sure to place the wooden block between the front disc brake piston which is not to be removed and the front disc brake cylinder.
Apply compressed air to remove the front disc brake piston from the front disc brake cylinder.
Do not place your fingers in front of the front disc brake piston when using compressed air.
Do not allow any brake fluid to spatter.
2.REMOVE CYLINDER BOOT
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the cylinder boot from the front disc brake cylinder.
Be careful not to damage the front disc brake cylinder.
3.REMOVE PISTON SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the front disc brake cylinder.
Do not damage the inner surface or piston seal groove of the front disc brake cylinder.
31478B
4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
47547B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG