Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0109285 LANE DEPARTURE ALERT SWITCH G

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSPECTION  


PROCEDURE

Hide 84978 1.INSPECT LANE-KEEPING ASSIST MAIN SWITCH

a.
E284064
1.26,1.781 1.469,1.323 true 2.177,1.771 1.969,1.313 true 0.125,0.125 0.438,0.323 0.313,0.198 10 false *a 2.083,1.802 2.542,2 0.458,0.198 10 false GND 1.094,1.802 1.552,2 0.458,0.198 10 false ECU
*a Component without harness connected
(Lane-keeping Assist Main Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (ECU) - 6 (GND) Lane-keeping assist main switch on Below 1 Ω
3 (ECU) - 6 (GND) Lane-keeping assist main switch off 10 kΩ or higher


If the result is not as specified, replace the lane-keeping assist main switch.


b.

Check that the lane-keeping assist main switch illuminates.

i.
E284064
1.448,1.771 1.615,1.323 true 2.042,1.76 1.813,1.313 true 0.104,0.094 0.417,0.292 0.313,0.198 10 false *a 1.958,1.802 2.573,2 0.615,0.198 10 false ILL- 1.323,1.802 1.938,2 0.615,0.198 10 false ILL+
*a Component without harness connected
(Lane-keeping Assist Main Switch)


Apply battery voltage to the lane-keeping assist main switch connector and check that the lane-keeping assist main switch illuminates.

OK:
Connection Specified Condition
Battery positive (+) → Terminal 4 (ILL+)
Battery negative (-) → Terminal 5 (ILL-)
Illuminates


If the result is not as specified, replace the lane-keeping assist main switch.