Home › General › SPECIFICATIONS › 2GR-FE STARTING › 2013.12–2016.11
RM3160E _V1 General _019682 SPECIFICATIONS _0095378 2GR-FE STARTING F

SPECIFICATIONS  2GR-FE STARTING  SERVICE DATA  


Starter assembly Standard current: Below 90 A at 11.5 V
Repair service starter kit Standard resistance
Terminal 50 - Terminal C: Below 1 Ω
Standard resistance
Terminal 50 -Magnet switch body: Below 2 Ω
Starter armature assembly Standard resistance
Segment - Segment: Below 1 Ω
Standard resistance
Commutator - Starter armature core: 10 kΩ or higher
Standard length: 3.1 mm (0.122 in.)
Maximum length: 3.8 mm (0.150 in.)
Starter commutator end frame Standard length: 9.0 mm (0.354 in.)
Minimum length: 4.0 mm (0.157 in.)
Standard resistance
Positive (+) brush - Negative (-) brush: 10 kΩ or higher
Snap ring Maximum length: 5.0 mm (0.197 in.)
Starter relay 3 - 5: 10 kΩ or higher (Battery voltage not applied to terminals 1 and 2)
3 - 5: Below 1 Ω (Battery voltage applied to terminals 1 and 2)
Engine switch Standard resistance
5(SS1) - 6(AGND) (Not pushed)
1(SS2) - 6(AGND) (Not pushed)
10 kΩ or higher
Standard resistance
5(SS1) - 6(AGND) (Pushed)
1(SS2) - 6(AGND) (Pushed)
Below 1 Ω
Ignition or starter switch assembly Standard resistance
Between all terminals (LOCK)
10 MΩ or higher
Standard resistance
5 (AM1) - 7 (ACC) (ACC)
Below 1 Ω
Standard resistance
5 (AM1) - 7 (ACC) - 8 (IG1) (ON)
Standard resistance
3 (IG2) - 4 (AM2) (ON)
Standard resistance
5 (AM1) - 6 (ST1) - 8 (IG1) (START)
Standard resistance
2 (ST2) - 3 (IG2) - 4 (AM2) (START)