Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Manual Seat)
RM3160E _58 Vehicle Interior _019712 SEAT _0109367 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

If the front seat airbag assembly was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

·

If the front seat airbag sub-assembly RH was deployed, replace the front seat airbag sub-assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion pad and separate type front seat cushion cover with the necessary parts in accordance with the extent of the collision damage.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 71910A 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest assembly from the front seat assembly.


Hide 72124 4.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER

a.

Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.


b.
B362210

Disengage the 2 claws as shown in the illustration.


c.
B362211

Disengage the 2 guides to remove the front outer seat track bracket cover as shown in the illustration.


Hide 72128A 5.REMOVE FRONT INNER SEAT TRACK BRACKET COVER

a.
B362207

Disengage the 2 claws as shown in the illustration.


b.
B362208

Disengage the 2 guides to remove the front inner seat track bracket cover as shown in the illustration.


Hide 72138B 6.REMOVE SEAT TRACK COVER

a.

Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.


b.
B362204

Disengage the 2 claws as shown in the illustration.


c.
B362205

Disengage the 2 guides to remove the seat track cover as shown in the illustration.


Hide 72158 7.REMOVE INNER SEAT TRACK BRACKET COVER

a.
B362201

Disengage the 2 claws as shown in the illustration.


b.
B362202

Disengage the 2 guides to remove the inner seat track bracket cover as shown in the illustration.


Hide 8.REMOVE FRONT SEAT ASSEMBLY (for Driver Side)

a.
B362196

Remove the 2 bolts on the rear side of the front seat assembly.


b.

Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.


c.
B362199

Remove the 2 bolts on the front side of the front seat assembly.


d.

Operate the vertical adjusting handle and move the front seat assembly to the uppermost position.


e.

Lift up the seat track adjusting handle and move the front seat assembly to the center position.


f.

Operate the reclining adjuster release handle and move the seatback to the upright position.


g.

Disconnect the front seat airbag assembly connector under the front seat assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.
B279750C14
1.771,1.094 2.333,1.094 true 1.938,1.438 2.5,1.438 false 1.083,1.385 1.646,1.385 true 2.385,1.021 2.698,1.177 0.313,0.156 10 false *a 2.563,1.375 2.875,1.531 0.313,0.156 10 false *b 0.979,1.323 1.104,1.51 0.125,0.188 10 false A
*a White Housing Lock
*b Yellow CPA
V100135

Slide


Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)


ii.

Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting the connector.




h.

Disconnect each connector and disengage each clamp under the front seat assembly.


i.
B362200

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.



Hide 9.REMOVE FRONT SEAT ASSEMBLY (for Front Passenger Side)

a.
B362253

Remove the 2 bolts on the rear side of the front seat assembly.


b.

Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.


c.
B362254

Remove the 2 bolts on the front side of the front seat assembly.


d.

Lift up the seat track adjusting handle and move the front seat assembly to the center position.


e.

Operate the reclining adjuster release handle and move the seatback to the upright position.


f.

Disconnect the front seat airbag assembly connector under the front seat assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.
B279750C14
1.771,1.094 2.333,1.094 true 1.938,1.438 2.5,1.438 false 1.083,1.385 1.646,1.385 true 2.385,1.021 2.698,1.177 0.313,0.156 10 false *a 2.563,1.375 2.875,1.531 0.313,0.156 10 false *b 0.979,1.323 1.104,1.51 0.125,0.188 10 false A
*a White Housing Lock
*b Yellow CPA
V100135

Slide


Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)


ii.

Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting the connector.




g.

w/ Front Seat Airbag Sub-assembly RH

i.

Slide the slider to release the lock, and then disconnect the front seat airbag sub-assembly RH connector under the front seat assembly.

C190412C08
1.948,0.906 1.948,2.031 false 3.615,0.885 3.615,2 false 1.865,2.052 2.042,2.219 0.177,0.167 10 false *a 3.531,2.021 3.708,2.188 0.177,0.167 10 false *a
*a Slider - -
V100135

Slide - -


NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.




h.

Disconnect each connector and disengage each clamp under the front seat assembly.


i.
B362256

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.