Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM3160E _53 Suspension _019690 REAR SUSPENSION _0109432 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  INSTALLATION  


PROCEDURE

Hide 48790 1.INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

a.
C199901

Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut.

NOTICE:
·

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

·

Insert the bolt with the threaded end facing the rear of the vehicle.




b.
C199902N02
3.125,0.844 3.281,1.042 0.156,0.198 10 false A

Set the rear upper control arm assembly LH in the tightening position as shown in the illustration.

Reference Length (A):

24.3 mm (0.957 in.)



c.
C199901

Fully tighten the bolt.

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



Hide 48770A 2.INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 89516B 3.INSTALL SKID CONTROL SENSOR WIRE LH (for 2WD)

C202330

a.

Install the skid control sensor wire LH to the rear upper control arm assembly LH with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

Do not twist the skid control sensor wire LH when installing it.



Hide 89546 4.INSTALL REAR SPEED SENSOR LH (for AWD)

HINT:

Perform the same procedure as for the skid control sensor wire LH.


Hide 89516 5.INSTALL SKID CONTROL SENSOR WIRE RH (for 2WD)

a.
C202331

Install the skid control sensor wire RH to the rear upper control arm assembly RH with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

Do not twist the skid control sensor wire RH when installing it.



Hide 89545 6.INSTALL REAR SPEED SENSOR RH (for AWD)

HINT:

Perform the same procedure as for the skid control sensor wire RH.