Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM3160E _53 Suspension _019690 REAR SUSPENSION _0109435 REAR STABILIZER BAR G

REAR SUSPENSION  REAR STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48802 1.INSPECT REAR STABILIZER LINK SUB-ASSEMBLY

C066721

a.

Inspect the turning torque of the ball joint.

i.

Secure the rear stabilizer link sub-assembly in a vise using aluminum plates.

NOTICE:

Do not overtighten the vise.



ii.

Install the nut to the rear stabilizer link sub-assembly stud.


iii.

Move the stud back and forth several times. Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Standard Turning Torque:

0.05 to 1.96 N*m (0.6 to 19 kgf*cm, 0.5 to 17 in.*lbf)


HINT:

If the turning torque is not within the specified range, replace the rear stabilizer link sub-assembly with a new one.




b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

HINT:

If the dust cover is cracked or there is grease on it, replace the rear stabilizer link sub-assembly with a new one.