Home › Drivetrain › MF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM
RM3160E _52 Drivetrain _019685 MF1A TRANSFER / 4WD / AWD _0109466 DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM U

MF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM  TERMINALS OF ECU  


CHECK 4WD ECU ASSEMBLY


C270073
3.385,0.135 3.813,0.438 0.427,0.302 3.469,0.208 3.938,0.375 0.469,0.167 10 false F14

a.

Measure the voltage and resistance of the connector.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F14-10 (4WDL) - F14-4 (GND) BE - BR AWD lock switch signal Ignition switch ON
AWD lock switch OFF → ON
11 to 14 V → Below 1 V
F14-6 (CANH) - F14-5 (CANL) L - W HIGH-level CAN bus wire - LOW-level CAN bus wire Cable disconnected from negative (-) battery terminal 54 to 69 Ω
F14-4 (GND) - Body ground BR - Body ground Ground Always Below 1 Ω
F14-3 (IG1) - F14-4 (GND) B - BR Power source voltage Ignition switch ON 11 to 14 V
F14-2 (SLC+) - F14-1 (SLC-) G - R 4WD linear solenoid signal Shift lever in D, idling Pulse generation (See waveform 1)

If the result is not as specified, the 4WD ECU assembly may have a malfunction.


b.
C170221
2.917,1.729 3.271,1.865 0.354,0.135 10 GND

Using an oscilloscope, check the waveform 1.

Waveform 1 (Reference)
Item Content
Terminal No. (Symbol) F14-2 (SLC+) - F14-1 (SLC-)
Tester Range 2 V/DIV., 1 msec./DIV.
Condition Shift lever in D, idling