Home › Engine / Hybrid System › 1AR-FE (ENGINE MECHANICAL) › DRIVE BELT
RM3160E _51 Engine / Hybrid System _019672 1AR-FE ENGINE MECHANICAL _0109589 DRIVE BELT A

1AR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 16361A 1.INSTALL V-RIBBED BELT

a.
A194911
2.125,0.281 2.323,0.281 2.323,0.281 2.698,0.594 false 3.083,1.219 2.938,1.219 2.938,1.219 2.708,1.396 false 1.26,0.688 1.438,0.688 1.438,0.688 1.688,0.948 false 0.448,1.406 0.594,1.406 0.594,1.406 0.781,1.792 false 2.073,3.24 2.219,3.24 2.219,3.24 2.375,3.01 false 0.24,1.344 0.406,1.5 0.167,0.156 10 false *1 1.938,0.208 2.104,0.396 0.167,0.188 10 false *3 1.063,0.594 1.24,0.76 0.177,0.167 10 false *2 1.885,3.156 2.042,3.323 0.156,0.167 10 false *5 3.125,1.146 3.281,1.292 0.156,0.146 10 false *4
*1 Crankshaft Pulley
*2 V-ribbed Belt Tensioner Assembly
*3 Generator Assembly
*4 Engine Water Pump Assembly
*5 Cooler Compressor


Set the V-ribbed belt onto each part as shown in the illustration except the engine water pump pulley.


b.

Loosen the V-ribbed belt by turning the belt tensioner clockwise.


c.

Set the V-ribbed belt onto the engine water pump pulley.

NOTICE:

Make sure that the V-ribbed belt is securely fitted into the grooves of each pulley.