Home › Engine / Hybrid System › 1AR-FE (ENGINE MECHANICAL) › DRIVE BELT
RM3160E _51 Engine / Hybrid System _019672 1AR-FE ENGINE MECHANICAL _0109589 DRIVE BELT G

1AR-FE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT V-RIBBED BELT

a.
A058797
1.24,0.156 1.51,0.365 0.271,0.208 10 false *a
*a Incorrect


Check the V-ribbed belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the V-ribbed belt.

·

The V-ribbed belt is cracked.

·

The V-ribbed belt is worn out to the extent that the cords are exposed.

·

The V-ribbed belt has chunks missing from the ribs.



b.
A087787
0.531,1.156 1.042,1.396 0.51,0.24 10 false *a 2.198,1.156 2.573,1.417 0.375,0.26 10 false *b
*a Correct
*b Incorrect


Check that the V-ribbed belt fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the V-ribbed belt has not slipped out of the groove on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.