Home › Engine / Hybrid System › 1AR-FE (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL
RM3160E _51 Engine / Hybrid System _019672 1AR-FE ENGINE MECHANICAL _0109593 REAR CRANKSHAFT OIL SEAL A

1AR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 32101 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

a.

Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.

NOTICE:
·

Using height adjustment attachments and plate lift attachments, place the engine assembly horizontally.

·

To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.

·

Using an engine sling device and engine lift, secure the engine assembly before service.




b.
A195875N16
1.375,1.26 0.854,1.26 false 1.292,0.781 1.146,0.781 1.146,0.781 1.146,1.26 false 0.49,1.177 0.823,1.333 0.333,0.156 10 false SST

Using SST, hold the crankshaft pulley.

SST
09213-54015  
09330-00021  

HINT:

SST (crankshaft pulley holding tool) fixing bolt part No.: 91551-80650 (2 pcs)



c.
A196849

Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly, and rear drive plate spacer.


Hide 11401L 3.REMOVE REAR ENGINE OIL SEAL

a.
A293109C10
2.813,1.646 2.813,1.521 2.813,1.521 3.083,1.01 false 1.104,1.531 0.625,1.177 0.625,1.177 0.385,1.177 true 2.74,1.667 3.052,1.823 0.313,0.156 10 false *b 0.208,1.083 0.521,1.281 0.313,0.198 10 false *a
*a Protective Tape
*b Cut Position


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a screwdriver, pry out the rear engine oil seal.

NOTICE:

Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.


HINT:

Tape the screwdriver tip before use.