Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2013.12–2016.11
RM3160E _59 Vehicle Exterior _019724 EXTERIOR PANELS / TRIM _0109633 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


PROCEDURE

Hide 53111 1.REMOVE RADIATOR GRILLE

Hide 75086 2.DISCONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH

a.
B361058
2.802,1.49 3.042,1.49 true 3.094,1.396 3.292,1.573 0.198,0.177 10 true *1 1.302,2.104 1.49,2.26 0.188,0.156 10 true *a
*1 Pin Hold Clip
*a 90°


Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.


b.

Remove the 2 screws.


c.

Remove the clip.


d.
B363577

Remove the clip.


e.
B367882
0.875,1.438 1.188,1.594 0.313,0.156 10 false *a
*a Push


Pull back the edge of the front fender liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

NOTICE:
·

Do not apply excessive force when pulling back the front fender liner LH.

·

To avoid damaging the claws, do not forcibly pull the front fender wheel opening moulding sub-assembly LH.




f.

Disengage the 2 clips and disconnect the front fender wheel opening moulding sub-assembly LH.


Hide 75085A 3.DISCONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 4.REMOVE FRONT BUMPER ASSEMBLY

a.
B361061
1.385,1.021 1.521,1.021 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly.


b.
B361062

Remove the 8 screws.


c.
B361063
2.677,3.302 3.01,2.948 true 3.052,2.854 3.24,3.031 0.188,0.177 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the claw as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



d.
B361064

Disengage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



e.
B361066

Pull back the side of the front bumper assembly, disengage the clamp and disconnect the 2 connectors.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.


HINT:

Use the same procedure for the RH side and LH side.



f.

w/ Headlight Cleaner System:

i.
B361071

Pull back the side of the front bumper assembly and disconnect the headlight cleaner hose.


ii.
B361072

Drain the washer fluid.

HINT:

Use a container to collect the washer fluid.




g.
B361069

Remove the 3 clips and front bumper assembly as shown in the illustration.