Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR OUTSIDE MOULDING
RM3160E _59 Vehicle Exterior _019724 EXTERIOR PANELS / TRIM _0109644 FRONT DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR OUTSIDE MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75793 1.INSTALL FRONT DOOR UPPER OUTSIDE MOULDING PAD

a.

Clean the front door outside moulding.

i.

Remove any double-sided tape from the front door outside moulding.


ii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new front door upper outside moulding pad.

i.

Remove the release paper from the new front door upper outside moulding pad.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



ii.

Install the front door upper outside moulding pad as shown in the illustration.

B362543
0.615,0.677 0.854,0.427 0.854,0.427 0.5,0.677 false 6.896,0.677 6.354,0.396 6.354,0.396 6.583,0.688 false 0.906,0.344 1.219,0.5 0.313,0.156 10 false *a 6.177,0.323 6.49,0.479 0.313,0.156 10 false *a
*a Marking - -




Hide 2.INSTALL FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY

HINT:

When installing the front door outside moulding sub-assembly, heat the vehicle body and front door outside moulding sub-assembly using a heat light.


Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Front Door Outside Moulding Sub-assembly 20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body or front door outside moulding sub-assembly excessively.


a.

Install 10 new clips.


b.

Install a new gasket.


c.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove any double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



d.

Install the front door outside moulding sub-assembly.

i.

Using a heat light, heat the vehicle body and front door outside moulding sub-assembly.


ii.

Remove the release paper from the front door outside moulding sub-assembly.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



iii.

Engage the 10 clips and attach the double-sided tape.

HINT:

Press the front door outside moulding sub-assembly firmly to temporarily install it.



iv.

Install the nut.


v.

Install the hole plug.


vi.

Engage the 6 clips to install the front door outside moulding sub-assembly.

B362538