Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › QUARTER PANEL WHEEL OPENING MOULDING
RM3160E _59 Vehicle Exterior _019724 EXTERIOR PANELS / TRIM _0109650 QUARTER PANEL WHEEL OPENING MOULDING A

EXTERIOR PANELS / TRIM  QUARTER PANEL WHEEL OPENING MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 61668C 1.INSTALL NO. 2 QUARTER PANEL SEAL

HINT:

When installing the No. 2 quarter panel seal, heat the vehicle body and No. 2 quarter panel seal using a heat light.


Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
No. 2 Quarter Panel Seal 20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body or No. 2 quarter panel seal excessively.


a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove any double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new No. 2 quarter panel seal.

i.

Using a heat light, heat the vehicle body and No. 2 quarter panel seal.


ii.

Remove the release paper from the new No. 2 quarter panel seal.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



iii.

Attach the double-sided tape.

HINT:

Press the No. 2 quarter panel seal firmly to temporarily install it.



iv.

Install a new grommet.


v.

Install the No. 2 quarter panel seal with the 4 screws.



Hide 75874 2.CONNECT QUARTER PANEL WHEEL OPENING MOULDING

a.

Engage the 4 clips.


b.

Install the 2 clips.


c.

Connect the quarter panel wheel opening moulding with the screw.